FAQs

We have standard pallet size: 113x93x98cm (length x width x height). Three layers in 1 pallet, each layer has 20 boxes.

Tiles are put face to face into cartoon boxes. Between the tiles, there are white papers to protect tile surface. Then, boxes are put into wooden pallets. Pallets will be loaded into container. Please click here for more details.
 

Each 20ft container can be loaded with 20 to 24 pallets depending on the maximum tonnage allowed by shipping companies. For tiles of 1.6cm thickness, each pallet has 60 boxes equal to 28.8sqm, totally we could load 691.20sqm in 1 container 20ft. In case of thin tile 1.2cm, we could load up to 920sqm in one 20ft container.  Please click here for packing details.
 

Before installation, please keep tiles in boxes in a dry place. Avoid being in contact with water or humidity as it may cause tiles to be stained.

If the floor is properly sealed, it will not absorb stains. However, when there is coffee, tea, wine, acids, etc. on the floor, they should not be left to sit on the tile for long as they will eventually eat through the sealer and stain the tile.

The floor should be cleaned with pH-neutral soap and water. Do not use any acids or bleach on these tiles! Please click here for our detailed instruction on encaustic cement tile floor maintenance.

Yes, it is very important that encaustic cement tile floor has to be sealed. Cement tile is a porous material that absorbs stains and dirt if not properly sealed. There are two general types of sealers: penetrating and topical. Penetrating sealers are absorbed into the cement and make it more difficult for the stain to adhere to the cement. Topical sealers sit on the surface of the tile and do not let the stain through. We recommend you use a good penetrating sealer to protect the floor after installation.

For our encaustic cement tiles, the floor will not be ground or polished after installation. Therefore, it is necessary to pay attention to levelling the tiles during installation to have a perfectly flat floor.

For our encaustic terrazzo, there is no need to grind or polish the floor after installation. However, in some countries, the encaustic terrazzo floor is ground and polished after installation. In these cases, please pay attention not to grind more than 1mm away from the top layer (as the thickness of first layer in our encaustic terrazzo is about 3mm).

Fill the joints with grouting liquid. For the grouting color, you can choose either white grout or colored grout. White grout matches most of the cases. However, for colored grout, please choose the color which is the same with the color of tile or pattern in the tile. DO NOT use black or dark grouting liquid as it may stain the floor.